mypros+
Error code reference

Admiral Washer Error Codes

21 error codes documented with diagnostic procedures.

Have your model number? Get codes specific to your unit.
F0E2Over suds condition detected-suds prevent the basket from spinning up to speed or the…F0E4High water temperature detected during rinse cycle (105°F or higher).F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control fault-fault of the motor control section of the main control.F2E1Stuck key-one or more keys on the User Interface were actuated for 15 consecutive seconds.F2E3Mismatch of main control and UI-the User Interface identification does not match the…F3E1Pressure system fault-main control detects an out of range pressure signal.F3E2Inlet water temperature fault-inlet thermistor detected to be open or shorted.F5E1Lid switch fault-lid is in locked state but lid switch is open; control not sensing the…F5E2Lid lock fault-lid lock has not moved into locked position or motor cannot be powered.F5E3Lid unlock fault-lid lock has not moved into unlocked position or motor cannot be powered.F5E4Lid not opened between cycles-user presses START after several consecutive washer cycles…F7E1Basket speed fault-main control cannot determine speed of basket, or speed changes too…F7E5Shifter fault-main control cannot determine position of shifter.F7E6Motor fault-indicates an open clockwise or counterclockwise circuit of the motor.F7E7Motor unable to reach target RPM-basket speed sensor detects that target RPM was not…F8E1No fill / long fill-water level does not change for a period of time or water is present…F8E3Overflow condition-main control senses water level that exceeds the washer's capacity.F8E5Hot and cold inlet hoses are reversed.F9E1Long drain-water level does not change after the drain pump is on for 10 minutes.

Get the full diagnostic procedure for any code

Step-by-step tests, expected values, wiring diagram references, and verified part numbers.

Get Started $9.95 3-day pass

$29/month for unlimited access to all brands and Max AI diagnostics.

Common questions

How do I find the error code on my Admiral Washer?
Most Admiral washers show the code directly on the control panel display. If your model has no display, it can be read by entering diagnostic mode with the key sequence for your model. The full procedures include model-specific instructions for reading codes.
Are these codes specific to my model?
The codes here apply broadly to Admiral washers. Meanings and diagnostic steps can vary by model and production year, so enter your model number for model-specific information and procedures.
What do I do if my code is not listed?
Some codes are model-specific or only appear in diagnostic mode. Enter your model number to get codes specific to your unit, or contact us. We update the database continuously from manufacturer service documentation.
How much does it cost to access the full diagnostic procedures?
A 3-day pass is $9.95 one-time and gives full access to all brands, codes, and procedures. Monthly access is $29/month with unlimited access to everything including Max AI diagnostics.