Error code reference

Amana Washer Error Code E10

Out of balance: vibration switch/out of balance sensor was activated or inverter sensor imbalance.

SourceAmana Microwave - ADC EWH-40M2 ServiceManual-EcoSmart-Medium,HighSpeed-M-Models PastProduction OPL: ER1p. 11

Diagnostic procedure

The full E10 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Run washer; if problem persists check lag bolts, shocks, springs, and belt.

SourceAmana Microwave - ADC EWH-40M2 ServiceManual-EcoSmart-Medium,HighSpeed-M-Models PastProduction OPL: ER1p. 11

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock E10 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

1 manual in the MyPros+ library documents this code for Amana washer.

Models covered by the manuals that document this code

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full E10 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Amana washer error codes