mypros+
Error code reference

Amana Washer Error Code F3

Lid Switch Failure - The lid was NOT opened after the cycle was completed; the electronic board must detect STOP/CANCEL was pressed or the lid was opened at least once at the end of any cycle.

SourceWasher - Tech Sheet: Display Fault/Error Codes (3954356)p. 2

Amana codesAmana washer codes
Diagnostic procedure

The full F3 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check continuity of the lid switch. With lid closed, contacts should be closed; with lid open, contacts should be open. If lid switch failed, replace it. If lid switch is good, replace the control board.

SourceWasher - Tech Sheet: Display Fault/Error Codes (3954356)p. 2

Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F3 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

1 manual in the MyPros+ library documents this code for Amana washer.

Models covered by the manuals that document this code

Related Amana washer error codes

All Amana washer codes

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax