Bosch Dishwasher Error Code 0

Code 0 means the dishwasher completed its internal test program and detected no faults. It is a pass result, not an error. No repairs are needed based on this code alone. If you are still experiencing a performance problem, the fault may be intermittent or outside the range of what the test program monitors.

Pressing the Start button or opening and closing the door will typically return the display to the normal cycle selection mode. Code 0 clears on its own once you exit the test program by pressing the On/Off button or selecting a wash program.

Code 0 requires no repair and costs nothing to resolve. It is a confirmation that all tested systems passed diagnostics. If a technician was called and found code 0, the visit cost reflects the service call fee only, typically $75 to $150 depending on your area, not any parts or repair work.

Yes. Code 0 is not a fault code and does not indicate any malfunction. Your dishwasher is fully operational. Simply close the door and run a normal wash cycle as usual.

You likely triggered the service diagnostic test program by pressing a specific button combination, often holding two buttons simultaneously during power-on. Check your model's service mode entry sequence in the owner manual. Press On/Off to exit the test program, then select your desired wash cycle normally.