Dcs Refrigerator Error Code R-FAN ERROR

The R-FAN ERROR indicates that the refrigerator compartment fan motor is not operating correctly and the control board is not receiving the expected F.G. feedback signal from the motor. This signal confirms the fan is spinning at the correct speed. The error can be caused by a loose or failed feedback signal wire, a disconnected wiring harness, or a defective fan motor.

Continuing to run the refrigerator with this error is not recommended. The R-Room fan circulates air through the refrigerator compartment, and if it is not operating, food temperatures may rise to unsafe levels. Address the fault as quickly as possible to prevent food spoilage.

Repair costs vary depending on the cause. If only a wiring connection needs to be reseated or a connector cleaned, costs may be limited to a service call fee, typically in the range of $75 to $150. If the fan motor itself requires replacement, parts and labor combined can range from $150 to $350 or more, depending on parts availability and local labor rates.

Some causes, such as a disconnected wiring harness or ice blocking the fan blade, can be addressed without specialized tools. However, diagnosing a feedback signal wire failure or testing motor operation requires familiarity with electrical connectors and wiring. If you are not comfortable working with appliance wiring and connectors, a qualified technician should handle the repair.

A power reset may temporarily clear the error display, but if the underlying cause, such as a wiring fault or motor defect, has not been corrected, the error will return once the control board attempts to run the fan again. The root cause must be diagnosed and repaired for the error to stay cleared.