Dcs Refrigerator Error Code R-SENSOR

R-SENSOR indicates a fault in the R-Room temperature sensor circuit. The control board displays this code when the sensor reports a temperature above 149°F or below -58°F, which signals a wiring, connection, or sensor hardware problem rather than an actual temperature extreme. Common causes include a loose sensor housing, a damaged wire, or a failed sensor.

A power reset may temporarily clear the display, but the code will return if the underlying hardware fault is not corrected. The control board will re-detect the out-of-range sensor reading each time it runs its diagnostic cycle. Proper repair of the sensor, wiring, or connector is required for a lasting fix.

If the fix is simply reseating the sensor or cleaning a connector, there may be no parts cost at all, with a service call fee being the primary expense, typically in the range of $75 to $150. If the sensor itself needs replacement, parts and labor combined generally fall in the range of $100 to $300 depending on your location and the technician's rates. Wiring harness repairs can vary widely based on the extent of the damage.

Some causes are DIY-friendly. Reseating a sensor that has slipped out of its bracket or reconnecting a loose connector requires no special tools and no parts. If wiring is cut or shorted, or if the sensor itself has failed, you will need replacement components and basic electrical diagnostic skills to resolve the fault safely.

The refrigerator may continue running, but the control board cannot accurately regulate compartment temperature without a functioning sensor. This can lead to inconsistent cooling, potential food safety issues, or compressor cycling problems. It is best to address the fault promptly rather than continue operating the unit in a degraded state.