Skip to main content
Error code reference
Edgestar Ice Maker Error Code H
Cabinet temperature sensor detected the temperature is 17°F higher than set temperature for more than 15 minutes.
SourceEdgeStar OBR900SS - Full Service Manual (V1.0)p. 22
Diagnostic procedure
The full H procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check the cooling system for possible problems as outlined in 'Unit not Cooling' and 'Unit Not Cooling Enough' sections.
SourceEdgeStar OBR900SS - Full Service Manual (V1.0)p. 22
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock H procedure $9.95
Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.
Where this code is documented
1 manual in the MyPros+ library documents this code for Edgestar ice maker.
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax