Skip to main content
Error code reference
Edgestar Washer Error Codes
30 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
E10After 7 minutes, the water level doesn't change with valves openE11Significant water remains in the unit when unit is in standby or at end of cycle.E12Water level in drum exceeds appropriate level for alarm (overflow condition).E20The main PCB doesn't receive pump signal.E21After 3 minutes, the water level doesn't change with pump started (drain failure).E30Door will not lock after 3 attempts.E31Door will not unlock after 3 attempts.E33The main PCB is not receiving the water switch (water level sensor) signal.E34Temperature sensor on water heater open circuit.E35Temperature sensor on water heater short circuit.E36Water heater will not work due to failed temp sensor or heater.E37Drum drying outlet temperature sensor failed; drying function will not work.E38Drum drying inlet temperature sensor failed; drying function will not work.E3ADrying heater open circuit; drying function will not work.E40EEPROM failedE50/E52Inverter PCB overload; unit can't work.E50/E53Inverter module temperature failure; unit can't work.E50/E55Motor speed signal lost; unit will stop operation.E50/E56Motor temperature over-protection; unit will stop operation.E50/E57Inverter connection failure; unit will stop operation.E50/E58Inverter module temperature failure / inverter module failure; unit will stop operation.E50/E5AConnection failure between inverter module and main control PCB; unit will stop operation.E50/E5BInverter module failure; unit will stop operation.E50/E5COver voltage on inverter module; unit will stop operation.E50/E5DLow voltage on inverter module; unit will stop operation.E50/E5EInverter module failure; unit will stop operation.E64Signal between main PCB and inverter PCB is abnormal; unit will stop operation.E70Button blocked/stuck; unit can't work.E80The main PCB cannot get signal from display PCB; unit can't work.E81The main PCB cannot get signal from display PCB; unit can't work.
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.