Electrolux Refrigerator Error Code 93

Error code 93 indicates a shorted C/F key or button on the Perfect Temperature Drawer control panel. The refrigerator has detected a continuous signal from this button, which it interprets as an electrical short rather than a normal button press. This fault is specific to the Perfect Temperature Drawer and may affect temperature control in that compartment.

The rest of the refrigerator compartments may continue operating normally while code 93 is active, but the Perfect Temperature Drawer may not regulate temperature correctly. It is advisable to avoid storing sensitive items like raw meat in that drawer until the fault is resolved. Monitor the drawer's temperature closely if you continue using the appliance.

A power reset may temporarily clear the error code, but if the underlying short in the C/F button or wiring is still present, the code will return once the refrigerator restarts and detects the fault again. A reset is useful for confirming whether the issue is intermittent, but it is not a permanent fix for a physical button short or component failure.

In some cases, yes. Start by inspecting the C/F button on the Perfect Temperature Drawer for visible damage, debris, or moisture. Carefully cleaning the control panel surface to remove any residue under or around the button may resolve the issue if contamination is the cause. If the button is physically damaged or the panel board has failed, replacement parts will be needed and the repair may require a technician.

Repair costs vary depending on the root cause. If cleaning resolves the issue, there is no parts cost. Replacing the Perfect Temperature Drawer control panel or switch assembly typically ranges from $80 to $250 in parts, with labor adding $100 to $200 if a technician is used. Wiring harness replacement costs fall in a similar range depending on accessibility.