Electrolux Refrigerator Error Code F2

The F2 code on an Electrolux refrigerator means the control board has detected a defective evaporator sensor in the refrigerator compartment. This thermistor sensor monitors compartment temperature and sends resistance-based feedback to the control board. When the resistance reading falls outside the expected range, the board registers the F2 fault and may limit or halt normal cooling operation.

It is not recommended to rely on the refrigerator for food storage while the F2 fault is active. Without a functioning evaporator sensor, the control board cannot accurately regulate cooling, which means food temperatures may rise into unsafe ranges without any visible indication. You should address the fault promptly and monitor internal temperatures if you continue using the unit temporarily.

Resetting the refrigerator by unplugging it for several minutes may temporarily clear the F2 code, but the error will return if the underlying sensor fault has not been corrected. A reset does not repair a failed thermistor or damaged wiring. The fault code should be treated as a symptom requiring diagnosis rather than an issue that can be resolved through a reset alone.

A knowledgeable DIYer can address some causes of the F2 error, such as clearing frost buildup around the sensor, reseating a dislodged sensor, or cleaning corroded connector pins. If the thermistor itself has failed, replacing it requires basic electrical skills and sourcing the correct replacement part. Control board replacement is more complex and is generally best left to a qualified technician.

Repair costs depend on the root cause. A replacement evaporator thermistor sensor typically costs in the range of $15 to $50 for the part. If professional labor is involved, total repair costs including diagnosis and installation generally range from $100 to $250. A control board replacement, if needed, can push costs significantly higher, often $200 to $400 or more for parts and labor.