Error code reference
Electrolux Refrigerator Error Code LO F
LCL under temperature time out exceeded (Perfect Temp Drawer).
LCL under temperature time out exceeded (Perfect Temp Drawer).
First step from the service manual
1
Check PTD thermistor, heater, and damper operation.
The complete diagnostic procedure includes additional test steps, resistance specifications, wiring diagram references, and component test points.
MyPros+ Max
Get the full diagnostic procedure for LO F.
- ✓Step-by-step tests with expected resistance, voltage, and continuity values
- ✓Wiring diagram references and connector pinouts from the OEM service manual
- ✓Verified part numbers when replacement is required
Get the full procedure→
$29/month · Cancel anytime · Or $9.95 3-day pass
M+
M+ Max·Electrolux Refrigerator
LO F on my Electrolux Refrigerator
M+
LCL under temperature time out exceeded
From Service Manual 711244, p.16:
1.Check PTD thermistor, heater, and damper operation.
2.Disconnect the sensor and measure resistance at the sensor body. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).
3.Check the sensor harness for opens and shorts. Back-probe the sensor pins at the control board connector; a reading outside 5 kΩ to 50 kΩ indicates a failed sensor.
Part 5304513033
Thermistor
Related Electrolux refrigerator codes
All Electrolux refrigerator codes →- _ _Incorrect voltage detected (127V unit connected to 220V) on…
- 1st LED blinkingFault in the temperature sensor (sensor disconnected or…
- 2Thermistor is open (displayed during start-up test or…
- 21Open NTC thermistor for the chamber (drawer) NTC on Perfect…
- 22Open NTC thermistor for the freezer NTC on Perfect…
- 2nd LED blinkingFault in the defrost sensor (sensor disconnected or…
- 2XOpen NTC where X is
- 3Thermistor sensor is shorted (displayed during start-up…
View all 92 Electrolux refrigerator codes
- 31Shorted NTC thermistor for the chamber (drawer) NTC on…
- 32Shorted NTC thermistor for the freezer NTC on Perfect…
- 38Freezer sensor shorted.
- 3XShorted NTC where X is
- 4Damper failure on Side-by-Side refrigerators equipped with…
- 41FF (Fresh Food) sensor open or shorted (see test 11/12…
- 5Any combination of two or more sensor/interface failures…
- 5HFresh Food Ice Maker tray thermistor short circuit detected.
- 91Shorted ON/OFF key/button on Perfect Temperature Drawer.
- 92Shorted + key/button on Perfect Temperature Drawer.
- 93Shorted C/F key/button on Perfect Temperature Drawer.
- 94Shorted
- 95Shorted control lock key/button on Perfect Temperature…
- 96Shorted down arrow key/button on Perfect Temperature Drawer.
- 97Shorted up arrow key/button on Perfect Temperature Drawer.
- 9XShorted key/button where X is
- AFAir filter replacement reminder
- board incompatibilityIndicates incompatibility between the power control board…
- CDClose the door to start dishwasher operation (also…
- CEIce maker communication lost between main board and ice…
- CFCommunication failure between main board and user interface…
- CLClose the door to start dishwasher operation (also…
- cooler sensor faultCooler air temperature sensor signal is out of range…
- dAMalfunctioning of freezer air temperature sensor (signal…
- dEIncompatibility between the electronic boards (power board…
- dFManual defrost mode is active (d and F displayed in freezer…
- EGeneral error indication
- E/FEvaporator fan motor test failed during startup self-test…
- E0No error detected by the system.
- E1Ice maker mold heater failure (Finger Evaporator ice maker).
- E11Dishwasher drain valve issue; insulation strip in the drain…
- E2Room temperature sensor damaged (installed on the display…
- E3Evaporator mounted sensor shorted circuit detected.
- E4Ice maker harvest motor stuck in fill position (cannot move…
- E5Showroom Mode is active; compressor, fan, and defrost…
- E6Ice maker harvest motor stuck in intermediate position…
- E7Stuck key detected (keypress read for longer than 30…
- E8Shorted thermistor condition; the temperature sensor…
- E9Open thermistor detected
- EdShorted or open defrost thermistor.
- eeprom errorEEPROM parameter writing/reading error on the electronic…
- ELShorted or open lower thermistor (also the default error…
- ErIce maker communication error or incompatible protocols…
- EUShorted or open upper thermistor.
- FEEV (Electronic Expansion Valve) test failed; temperature…
- F1Refrigerator compartment air sensor defective.
- F2Refrigerator compartment evaporator sensor defective.
- F3Freezer compartment air sensor defective.
- F4Freezer compartment evaporator sensor defective.
- F68High voltage or low voltage condition present in the power…
- F69High voltage or low voltage condition present in the power…
- FrIce maker is in Freezer Recovery Mode
- freezer sensor faultFreezer air temperature sensor signal is out of range…
- freezer temp alarmFreezer compartment temperature has reached -11°C or…
- HIndicates the HOLIDAY function is active on the cooler…
- HDThe dishwasher is in a heat delay (also displayed as HO).
- HIHigh temperature condition detected in fresh food (above…
- HI FUCL over temperature time out exceeded (Perfect Temp…
- High temp indicator blinkingSensor failure detected during operation
- HOThe dishwasher is in a heat delay (also displayed as HD).
- Ice CEIce maker communication lost with main control board.
- Ice ErIce maker IM/RAM error
- ICE t3Ice maker TH3 suction line thermistor open or shorted.
- IPIncompatible protocols between main board (PB) and ice…
- LJShow Room mode active on DF80/DF80X models; panel and…
- LOThe rinse aid in the dispenser is low; does not affect…
- locPanel lock indicator on DF80/DF80X models; control panel is…
- OPFresh food temperature sensor is open circuit (displayed in…
- OP (FZ)Open freezer cavity thermistor detected.
- P2Primary sensor open circuit detected.
- P3Primary sensor shorted circuit detected.
- PFThe dishwasher control has lost power and the power has…
- PoDoor open alarm on DF80/DF80X models; one or both doors…
- rAWater reservoir empty alert on DFI80/DI80X; ice maker…
- SHFresh food sensor shorted circuit detected (displayed in…
- SH (FZ)Shorted freezer cavity thermistor detected.
- SYSystem error code displayed on the user interface.
- SY CECommunication between the User Interface and Main Board was…
- SY CFCommunication was not established between UI and Main Board…
- SY EFEvaporator fan failure detected by the main control.
- t3Ice maker TH3 suction line sensor is open or shorted…
- UFThe control is not seeing the vent fan running properly…
- UIIncorrect user interface board detected.
- UOThe control believes the vent baffle is stuck open; this…
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started →$29/month · Cancel anytime · Or $9.95 3-day pass