Frigidaire Range Error Code 1c8c

Error code 1c8c indicates a CRC (Cyclic Redundancy Check) failure in the control board's memory, detected when a cooking or self-clean program is initiated. The control board validates stored program data using a checksum, and if that check fails, it means the data is corrupted or invalid. As a safety response, the board disables all outputs and requires a Power On Reset before any operation can resume.

No. When error code 1c8c is active, the control board intentionally disables all outputs, meaning the range cannot be used at all until the error is cleared. This is a protective shutdown, not just a warning. Do not attempt to bypass the control board or use the appliance until the error has been properly diagnosed and resolved.

If a simple power reset resolves the issue, there is no parts cost involved. If the electronic oven control board needs replacement, parts alone typically range from $150 to $350 depending on the specific model, with professional labor adding another $100 to $200 in most cases. Getting a diagnosis from a qualified technician before purchasing parts is recommended, since board pricing varies significantly by model.

A Power On Reset, performed by turning off the circuit breaker for several minutes and restoring power, is the required first step to clear this error. If the underlying memory corruption is minor or was caused by a one-time power event, the reset may resolve it. However, if the error returns immediately or on the next program attempt, the control board's memory has sustained permanent corruption and the board will need to be replaced.

Start by cutting power to the range at the circuit breaker for at least five minutes, then restore power to perform a Power On Reset. If the error clears and does not return, monitor the unit for recurrence. If the error comes back, inspect the wiring harness connections at the electronic oven control board for any loose or corroded connectors. If no wiring issues are found, the control board itself is the likely failed component and will need to be replaced.