Frigidaire Range Error Code door

On this 36-inch Frigidaire gas range, the door code means the control board is detecting an open lock switch while the oven is set to self-clean. The control expects the door latch to be fully engaged before the clean cycle can run. It signals that the circuit between pins 5 and 7 of the 8-pin plug at the control is not completing as expected. This prevents the self-clean cycle from starting or continuing safely.

Normal baking and broiling functions are not directly tied to the door lock switch, but you should avoid attempting to run the self-clean cycle until the fault is resolved. Running self-clean with a faulty latch or lock switch could mean the door is not properly secured at high cleaning temperatures. Addressing the fault before using the self-clean function is strongly recommended.

Repair costs vary depending on which component is at fault. A door lock switch assembly typically costs anywhere from $30 to $80 for the part alone. If a technician is needed for diagnosis and replacement, expect total repair costs in the range of $100 to $250 depending on labor rates in your area. A control board replacement, if required, would be at the higher end of the cost spectrum.

In many cases, yes. Start by making sure the latch handle is fully moved into the locked position, which resolves the error if the latch was simply not engaged. If the error remains, disconnect power and use a multimeter to check continuity between pins 5 and 7 of the 8-pin connector at the control board. Replacing a wiring connector or a faulty lock switch is a repair that a confident DIYer with basic electrical knowledge can often perform.

Disconnecting power to reset the control may temporarily clear the code, but the error will return as soon as a self-clean cycle is attempted if the underlying issue is not corrected. The control checks the lock switch status each time clean is programmed, so a reset alone is not a fix. The latch position, switch continuity, and wiring should all be inspected to permanently resolve the error.