Frigidaire Range Error Code E013

E013 indicates a bad or failed EEPROM on the ESEC User Interface Board. The EEPROM is a memory chip that stores configuration and operational data for the control system. When this chip fails or becomes corrupted, the range detects the fault and displays E013. The User Interface Board must be replaced to resolve the issue.

When E013 is active, the range's control system has detected a memory fault and may behave erratically or refuse to operate normally. It is best to avoid using the range until the User Interface Board has been replaced, as unpredictable control behavior in a cooking appliance presents a safety risk.

The cost depends on whether you replace the User Interface Board yourself or hire a technician. The UIB part itself typically falls in the range of $100 to $300 depending on the specific model. If you hire a technician, expect to add labor costs of roughly $100 to $200 on top of the part price, bringing the total repair estimate to approximately $200 to $500.

The required repair is replacement of the User Interface Board, which is a moderately involved task that requires disconnecting wiring harnesses and handling electronic components. A confident DIYer comfortable with appliance disassembly can perform this repair, but if you are unsure about working with electrical components, hiring a qualified appliance technician is the safer choice.

A power cycle by unplugging the range or switching off the circuit breaker for a few minutes may temporarily clear the E013 code. However, because the fault originates from a failed or corrupted EEPROM chip, the error will almost certainly return once power is restored. A reset alone is not a fix and board replacement is needed for a lasting repair.