Error code reference

Frigidaire Range Error Code E015

ESEC self test failed: may indicate the ESEC-UIB is not receiving a synchronization signal from the ESEC-Relay Board.

SourceFrigidaire Symmetry Range - Tech Sheet: Electronic Oven Control (CGEF306TMF Series)p. 7

Diagnostic procedure

The full E015 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

Check if J2 pin 5 on the ESEC-Relay Board is wired to P4 pin 5 on the ESEC-UIB. If wiring is good and the problem persists, replace the ESEC-UIB. If the problem still persists, replace the ESEC-Relay Board.

SourceFrigidaire Symmetry Range - Tech Sheet: Electronic Oven Control (CGEF306TMF Series)p. 7

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock E015 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

4 manuals in the MyPros+ library document this code for Frigidaire range.

Models covered by the manuals that document this code

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full E015 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Frigidaire range error codes