GE Monogram Ice Maker Error Codes

1 error code for GE Monogram ice maker models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

ON/OFF LED flashingSignifies an ice level sensor error.

MyPros+ Max

Get the full diagnostic procedure for any GE Monogram ice maker error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Monogram Ice Maker

ON/OFF LED flashing on my GE Monogram Ice Maker

M+

Signifies an ice level sensor error

From Service Manual 472708, p.40:

1.Unplug ice maker and remove the cutter grid cover. Make sure the white wiring connector going up to the control housing on the right side is connected securely.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part WPW10804018

Electronic control board

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started