Skip to main content
Error code reference
Hardwick Microwave Error Code F6E5
No cavity size command - cavity size has not been programmed.
SourceHardwick Range - Tech Sheet - W10153968 - Rev A: J-446p. 6
Diagnostic procedure
The full F6E5 procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Control should power up in cavity size select mode; press the correct cavity size and CONFIRM.
SourceHardwick Range - Tech Sheet - W10153968 - Rev A: J-446p. 6
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F6E5 procedure $9.95
Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.
Where this code is documented
2 manuals in the MyPros+ library document this code for Hardwick microwave.
Models covered by the manuals that document this code
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax