Skip to main content
Error code reference
Hardwick Microwave Error Code F7 E0
Water is not high enough or water did not boil fast enough.
SourceMicrowave Oven - Tech Sheet: Diagnostic & Service Procedures (W10153968B)p. 6
Diagnostic procedure
The full F7 E0 procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Enter Diagnostic mode (OFF, OFF, START) on lower oven display, press ERROR CODE to verify, then verify that the water system is connected with the product and check filter.
SourceMicrowave Oven - Tech Sheet: Diagnostic & Service Procedures (W10153968B)p. 6
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F7 E0 procedure $9.95
Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.
Where this code is documented
2 manuals in the MyPros+ library document this code for Hardwick microwave.
Models covered by the manuals that document this code
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax