LG Dryer Error Code CE1

CE1 means the compressor outlet temperature exceeded 115°C in an LG heat pump dryer. The dryer automatically shuts the compressor off and attempts to restart after 3 minutes. If this overtemperature condition repeats three times in a row, the CE1 code is displayed and the unit stops operating until the issue is resolved.

No. The CE1 error indicates the compressor has already overheated and shut down as a protective measure. Continuing to force operation without addressing the root cause risks further damage to the compressor and refrigerant system. Stop using the dryer until the cause of the overtemperature condition is identified and corrected.

Cost depends entirely on the cause. If the fix is simply improving room ventilation or cleaning the condenser, there may be no parts cost at all. A refrigerant system repair can range from roughly $150 to $400 or more depending on labor rates and the extent of the issue. A compressor replacement is the most expensive scenario, typically ranging from $300 to $600 or higher including labor.

In many cases, yes. Start by checking whether the room where the dryer is installed is excessively warm (35°C or above) or poorly ventilated. Also clean the lint filter and condenser if they are dirty. If these environmental and maintenance factors are not the cause, a refrigerant system problem or compressor fault will require a qualified technician.

A power reset may temporarily clear the display, but the error will return if the underlying cause is not fixed. The CE1 fault is triggered only after the overtemperature condition repeats three times, so the compressor protection logic will activate again under the same conditions. Address the root cause first before attempting a reset.