LG Dryer Error Code ELE

ELE indicates an Earth Leakage Breaker (ELB) sensor error on your LG dryer. The ELB sensor has detected irregular or unbalanced current flow in the dryer's electrical circuit, which can signal a leakage path to ground. The dryer stops operation as a safety measure to protect both the appliance and the user from potential electrical hazard.

A simple power reset is unlikely to permanently clear the ELE error if an underlying fault is present. The ELB sensor will continue to detect the irregular current condition and reactivate the code when the dryer is operated. The diagnostic process involves disconnecting the ELB connector and running a full cycle to isolate whether the sensor or another component is causing the fault.

Repair costs vary depending on which component is at fault. Replacing the ELB sensor alone is generally a lower-cost repair, while faults involving the heating element, motor windings, or extensive wiring damage can increase parts and labor costs significantly. In total, expect repair costs to range from around $80 to $350 or more depending on the specific components involved and local labor rates.

You should not continue using the dryer while the ELE code is active. This error indicates the ELB safety sensor has detected abnormal current behavior, which could point to a grounding or insulation fault. Running the appliance under these conditions poses a potential electrical safety risk, and the dryer should be inspected before further use.

Begin by disconnecting the ELB connector and running the dryer through one complete cycle. If the ELE error clears, the ELB sensor or its wiring is likely the faulty component and should be replaced. If the error persists after disconnecting the connector, the fault is in aging or degraded components elsewhere in the dryer, such as the heating element, motor, or wiring harness, which will need inspection and replacement.