LG Dryer Error Code LE1

LE1 on an LG dryer means the drive motor is restricted and failed to start after multiple attempts. The control board detected that the motor could not reach operating speed, so it shut the dryer down to protect the motor from damage. The cause is most often a mechanical obstruction in the blower or motor area, though a faulty wiring connector can also trigger this code.

Resetting the dryer by unplugging it for a few minutes may temporarily clear the code, but if the underlying restriction is still present, the LE1 fault will return as soon as the motor attempts to start again. The root cause, whether a physical blockage or a connector issue, must be resolved before the code will stay cleared.

If the fix is simply removing a blockage from the blower wheel, the repair may cost little to nothing beyond your time. Replacing a motor supporter bracket typically runs in the range of $15 to $50 for the part. If the drive motor itself needs replacement, parts and labor combined can range from $150 to $350 depending on the model and your location.

Start by unplugging the dryer and inspecting the blower wheel and motor supporter for physical obstructions like lint, debris, or foreign objects. Remove anything blocking the blower wheel and confirm the motor spins freely by hand. If no obstruction is found, check the motor connector assembly for loose or corroded terminals. If the motor itself is seized, it will need to be replaced.

No, you should not continue running the dryer while LE1 is active. A stalled or restricted motor draws significantly higher current than normal, which can overheat the motor windings and cause permanent motor failure or create a fire hazard. Keep the dryer unplugged until the restriction is identified and corrected.