LG Dryer Error Code PS

The PS code on an LG dryer indicates that the appliance is not receiving the correct 240-volt power supply it requires to operate. This can be caused by a tripped circuit breaker, a blown fuse, a power outage, or an improperly connected power cord at the terminal block on the back of the dryer. It reflects a problem with the incoming power rather than an internal component failure.

No, you should not attempt to operate the dryer while the PS code is active. The code indicates the dryer is not receiving correct power, and running appliances on improper voltage can damage internal components or create an electrical hazard. Resolve the power supply issue before resuming use.

If the fix is simply resetting a tripped breaker or replacing a fuse, the cost is minimal, typically a few dollars for fuses or no cost at all for a breaker reset. If the power cord needs replacement, parts generally range from 15 to 40 dollars depending on the cord type. If the issue involves household wiring or the terminal block connection and a licensed electrician is needed, service call costs typically range from 75 to 200 dollars or more depending on your region.

Start by going to your home's electrical panel and resetting the double-pole circuit breaker for the dryer circuit by switching it fully off and then back on. If your home uses a fuse panel, check for and replace any blown fuses. Next, inspect the power cord connection at the terminal block on the rear of the dryer to ensure all wires are securely and correctly attached. If the code persists after these steps, contact a qualified technician to test the circuit voltage.

Resetting the dryer alone will not clear the PS code if the underlying power supply problem has not been corrected first. Once the circuit breaker is reset, a blown fuse is replaced, or the power cord connection is properly secured, the code should clear when the dryer is powered back on. If the root cause is not addressed, the code will return immediately.