mypros+
Error code reference

LG Heat Pump Error Code P741

Outdoor unit discharge temperature 1 protection control.

LG codesLG heat pump codes
Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the P741 error code actually means

Your LG heat pump has detected that the temperature of the refrigerant leaving the compressor in the outdoor unit has gotten dangerously high, so the system has shut itself down to protect the compressor from damage. This is usually caused by a refrigerant leak, a blocked outdoor unit, or another issue with how the system is circulating refrigerant. A qualified technician should inspect the system before you try to restart it.

Diagnostic procedure

The full P741 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
Confirm the fault
Power cycle the unit: switch off the breaker for 60 seconds, then restore power. If the code returns, the fault is persistent and the procedure below isolates the cause.
Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock P741 procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of P741

Ranked by how often they cause this code
  1. 1Low refrigerant charge
  2. 2Restricted airflow across outdoor coil
  3. 3Faulty or stuck expansion valve
  4. 4Discharge temperature sensor fault
  5. 5Compressor mechanical degradation

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about P741

What does P741 mean on a LG heat_pump?
P741 on an LG heat pump means the outdoor unit discharge temperature 1 protection control has been activated. The system has detected that the refrigerant discharge temperature at the compressor outlet is too high and has entered a protective state to prevent compressor damage. This is a safety feature, not simply a sensor error, and the underlying cause should be diagnosed before restarting the unit.
Is it safe to keep running my heat pump with a P741 error?
No, you should not attempt to force the system to keep running while P741 is active. The protection control exists specifically to prevent compressor damage from thermal overload. Continued operation without resolving the underlying cause can result in complete compressor failure, which is a significantly more expensive repair than addressing the root issue early.
Will resetting my LG heat pump clear the P741 error?
A power reset may temporarily clear the P741 code and allow the unit to restart, but if the underlying cause is still present, the error will return, often quickly. Resetting without diagnosing and repairing the root cause risks repeated thermal stress on the compressor. A proper repair addressing the discharge temperature issue is necessary for the error to stay resolved.
Can I fix a P741 error myself?
Some basic checks, such as clearing debris from around the outdoor unit and ensuring airflow is not restricted, can be done by a homeowner. However, diagnosing and resolving the most common causes, including low refrigerant charge or a faulty expansion valve, requires EPA-certified refrigerant handling and professional equipment. It is recommended to have a licensed HVAC technician inspect the system.
How much does it cost to repair a P741 error on an LG heat pump?
Repair costs vary widely depending on the root cause. A simple coil cleaning or sensor replacement might cost anywhere from $100 to $300. Refrigerant leak detection, repair, and recharge typically runs $200 to $600 or more. A compressor replacement, if needed, can range from $1,200 to $2,500 or higher depending on the unit and labor rates in your area.

Related LG heat pump error codes

All LG heat pump codes

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass