Error code reference

Marvel Ice Maker Error Code Steady LED

A clean cycle was just initiated; LED will remain on for approximately 10 seconds.

Marvel codes Marvel ice maker codes

A clean cycle was just initiated; LED will remain on for approximately 10 seconds.

MyPros+ Max

Get the full diagnostic procedure for Steady LED.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts from the OEM service manual
Verified part numbers when replacement is required

Get the full procedure

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Marvel Ice Maker

Steady LED on my Marvel Ice Maker

M+

A clean cycle was just initiated

From Service Manual 949017, p.29:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part WPW10804018

Electronic control board

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Get the full diagnostic procedure for Steady LED.

Related Marvel ice maker codes