Miele Washer Error Code F4191

F4191 indicates an internal fault within the washer's control system. The main control board has detected a condition in its own processing or communication pathways that it cannot recover from automatically. The machine stops operation and displays this code to signal that service is required.

No, you should not continue running the washer while this code is active. The machine has halted operation specifically because it detected an internal control fault, and running it in this condition could lead to further damage to the electronics or an unsafe operating state. Disconnect the power until the fault is properly diagnosed.

Repair costs vary depending on the root cause. If a wiring connection is the issue, costs are generally limited to labor fees, typically in the range of 100 to 200 dollars. If the main control board requires replacement, parts and labor combined can range from 300 to 600 dollars or more depending on the specific model and your location.

Basic steps like performing a hard reset by unplugging the machine for several minutes and then restarting it are worth attempting first. However, if the code returns, the fault is likely a hardware issue with the control board or an associated wiring problem that requires a technician with Miele diagnostic tools to properly identify and repair.

A reset, performed by disconnecting the machine from power for several minutes, may clear the code if the fault was caused by a temporary memory or firmware state issue. If the code reappears after the reset, the underlying cause is a hardware or wiring problem that must be repaired before the machine will operate normally.