Sangiorgio Dryer Error Code F10

F10 means the drum did not reach its required operating speed. This fault only appears on SANGIORGIO dryers equipped with a Brushless DC (BLDC) motor. The control board monitors drum RPM during startup, and if the target speed is not achieved, the dryer stops and displays F10. The cause can be mechanical, such as a blocked drum or broken belt, or electrical, such as a faulty motor control module or sensor.

No, you should not attempt to continue using the dryer while F10 is active. The dryer has halted operation because the drum is not spinning correctly, which means laundry would not dry properly and the heating element could potentially overheat without airflow from drum movement. Turn the machine off and investigate the cause before running another cycle.

Turning the knob to OFF and restarting may clear the code temporarily if the fault was intermittent. However, if there is an underlying mechanical or electrical problem, the F10 code will return as soon as the dryer attempts to spin the drum again. The fault must be diagnosed and repaired to prevent the code from recurring.

Yes, the first step is to turn the programme rotary knob to the OFF position and then restart the dryer. This soft reset can clear the code if it was triggered by a temporary glitch. If the code returns immediately after restarting, a physical fault is present and further diagnosis is needed.

Repair costs depend on the faulty component. Replacing a drive belt is typically the least expensive fix, usually in the range of $20 to $80 for parts. A motor control module or BLDC motor replacement is more involved, with parts and labor potentially ranging from $150 to $400 or more depending on your location and the specific model.