Sharp Microwave Error Code EE35

EE35 on a Sharp microwave indicates an antenna rotation error affecting both MG1 and MG2 antennas. These antennas distribute microwave energy evenly throughout the cooking cavity by rotating during operation. When the control unit cannot confirm that either antenna is rotating correctly, it displays EE35 and halts operation to prevent damage or uneven heating.

No, you should not use the microwave while EE35 is active. The error indicates that the antenna rotation system has failed, which means microwave energy will not be distributed evenly. This can result in hot spots, component stress, and potential damage to the magnetron or other internal parts. Keep the microwave unplugged until the fault is diagnosed and repaired.

Repair costs vary depending on which component has failed. A wiring repair or connector replacement is typically the least expensive fix, while control unit or motor replacements can increase costs significantly. In general, expect professional diagnosis and repair to range from $80 to $250 or more depending on parts needed and local labor rates. If the microwave is older, it may be worth comparing repair costs against the price of a replacement unit.

Some basic checks, such as inspecting for obstructions around the antenna area or verifying that wiring connectors are firmly seated, can be performed carefully by a knowledgeable DIYer. However, diagnosing and replacing components like the control unit, antenna motors, or antenna sensor involves working near high-voltage parts and is best handled by a qualified technician. Never attempt internal repairs without unplugging the unit and allowing the high-voltage capacitor to discharge.

Unplugging the microwave and restoring power may temporarily clear the display, but EE35 will return if the underlying fault has not been corrected. The error is triggered by a real hardware condition involving the antenna motors, sensor, or wiring, so a reset alone does not resolve it. Persistent reappearance of EE35 after a reset confirms that a component needs inspection or replacement.