mypros+
Error code reference

U-Line Ice Maker Error Code STEADY_LED

Control board has power, no sensing problems, operation is normal.

U-Line codesU-Line ice maker codes
Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the STEADY_LED error code actually means

A steady LED on your U-Line ice maker means everything is working normally from an electrical standpoint. The machine has power and its internal checks have found no problems. You do not need to take any action based on this indicator alone.

Diagnostic procedure

The full STEADY_LED procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
Confirm the fault
Power cycle the unit: switch off the breaker for 60 seconds, then restore power. If the code returns, the fault is persistent and the procedure below isolates the cause.
Unlock with pass
Unlock with pass
Unlock with pass
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock STEADY_LED procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of STEADY_LED

Ranked by how often they cause this code
  1. 1Normal Unit Operation
  2. 2Unit Recently Powered On
  3. 3Previous Fault Condition Cleared
  4. 4All Sensors Reading Within Range

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about STEADY_LED

What does STEADY_LED mean on a U-Line ice_maker?
A steady LED on a U-Line ice maker means the control board has power and no sensing problems have been detected. It is a normal operation status indicator, not an error code. No diagnostic or repair action is required based on this indicator alone.
Is a steady LED on a U-Line ice maker a safety concern?
A steady LED is not a safety concern. It indicates normal operation with no detected faults. If you have other concerns about the unit's behavior, such as unusual sounds or leaks, those should be investigated separately and are unrelated to this indicator.
Will resetting my U-Line ice maker clear the steady LED?
A reset is not necessary to clear a steady LED because it is not an error condition. Resetting the unit will simply power the board off and back on, after which the LED should return to a steady state once the board completes its startup checks and confirms normal operation.
Do I need to fix anything when I see a steady LED on my U-Line ice maker?
No, a steady LED does not require any corrective action. It confirms the unit is operating normally from an electrical and sensor standpoint. If the unit is not making ice despite the steady LED, the issue is likely mechanical or related to water supply rather than the control board.
How much does it cost to repair the condition causing a steady LED on a U-Line ice maker?
A steady LED does not indicate a fault, so there is no repair cost associated with it. If you are troubleshooting an ice production problem alongside a steady LED, repair costs would depend on the specific mechanical or hydraulic issue found, and could range from around $50 to $300 or more depending on the component involved.

Related U-Line ice maker error codes

All U-Line ice maker codes

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass