Skip to main contentGet Started
Error code reference
U-Line Refrigerator Error Code Steady LED
Control board has power and operation is normal on CLR2060.
Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
What the Steady LED error code actually means
A steady LED on your U-Line CLR2060 refrigerator is a good sign, not a problem. It simply means the control board is powered on and the unit is running normally. No action is needed when you see this light.
Diagnostic procedure
The full Steady LED procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
MyPros+ · DiagnosticsStep 1 preview
1
Confirm the fault
Power cycle the unit: switch off the breaker for 60 seconds, then restore power. If the code returns, the fault is persistent and the procedure below isolates the cause.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock Steady LED procedure $9.95
Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.
Most common causes of Steady LED
Ranked by how often they cause this code
- 1Normal unit operation
- 2Successful power restoration after an outage
- 3Board recently replaced or reset
Most DIYers save hundreds by diagnosing before ordering parts.
Get Started
$29/month · Cancel anytime · Or $9.95 3-day pass
Questions people ask about Steady LED
What does Steady LED mean on a U-Line refrigerator?
On the U-Line CLR2060, a steady LED on the control board indicates that the board has power and the unit is operating normally. This is a status confirmation, not a fault or error code. No repair or reset is needed when this indicator is observed.
Is a steady LED on a U-Line refrigerator a safety concern?
No, a steady LED is not a safety concern. It indicates the control board is powered and functioning as expected. Only absent or blinking LED states would prompt further investigation into board or power supply conditions.
Will resetting the U-Line CLR2060 clear the steady LED?
A reset will not and should not clear the steady LED because it is not a fault indication. After any reset or power cycle, the steady LED should reappear once the control board reinitializes, confirming the board is powered and ready. If the LED does not reappear after power is restored, that would indicate a board power supply issue worth investigating.
Do I need to fix anything if I see a steady LED on my U-Line CLR2060?
No action is required. The steady LED is a positive status indicator confirming normal operation. If you are experiencing a separate performance issue such as improper cooling, investigate components like the compressor, fans, or thermistor rather than the control board.
How much does it cost to address a steady LED issue on a U-Line CLR2060?
Because a steady LED reflects normal operation rather than a fault, there is typically no repair cost associated with it. If you are diagnosing a separate performance complaint alongside this indicator, costs would depend on which downstream component requires service, generally ranging from around $50 to $400 or more for parts and labor depending on the component involved.
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass