Whirlpool Dryer Error Code d24

The d24 code means the dryer has detected a stuck lower button switch on the control panel. In response, it automatically disables the lower dryer cycle and lower dryer display functions for 30 seconds. If the stuck condition clears on its own, normal operation resumes without any manual intervention. If the button remains stuck, the code stays active until you clear it through the diagnostic mode.

The d24 code will clear automatically after 30 seconds if the stuck switch is no longer detected, so a full reset may not be necessary. If the button remains stuck or the fault persists, you will need to clear it manually through the dryer's diagnostic mode. Simply unplugging the dryer and plugging it back in may temporarily clear the display, but the code will return if the underlying issue is not resolved.

If the fix is as simple as cleaning debris from the control panel, the cost can be minimal. If the control panel overlay needs replacement, parts typically range from around $20 to $80 depending on the model. A user interface or control board replacement can range from $80 to $200 or more for parts, plus labor costs if you hire a technician.

In many cases, yes. Start by inspecting the control panel for debris, residue, or physical damage around the lower button and clean the surface carefully. If the button overlay is deformed or damaged, replacement of the panel or user interface board may be needed. If the issue is a faulty control board rather than a physical stuck button, that repair is more involved but still possible for a knowledgeable DIYer.

The d24 code itself does not indicate a hazardous failure, and the dryer is designed to continue operating with the affected button functions disabled. However, you should address the root cause promptly, especially if moisture intrusion is involved, as liquid inside a control panel can pose a longer-term reliability risk. Avoid using the dryer if you suspect liquid has entered the electronics.