Whirlpool Range Error Code F6

F6 on a Whirlpool range means the control board has detected an open circuit in the ambient console bimetal sensor, which monitors temperature at the control console. The board interprets an open signal as the console running too hot and stops normal operation to protect the electronics. The problem may be a genuinely overheating console, or it may be a faulty sensor or wiring issue.

Start by disconnecting power to the range and locating the console bimetal sensor, which is mounted near the control panel. Inspect the wiring connector at the sensor for looseness or corrosion and reseat it firmly. Then test the bimetal sensor for continuity using a multimeter; a good sensor will show continuity when cool. If the sensor is open, replace it. If the connector and sensor check out, test the wire harness for breaks between the sensor and the control board.

Disconnecting power for several minutes will clear the F6 code temporarily, but the code will return if the console bimetal circuit remains open. Resetting without addressing the cause does not fix anything and may allow console overheating to continue if that is the root problem. Use the reset only as part of diagnosis, not as a solution.

You should not continue using the range while F6 is active. The code exists to protect the control console electronics from heat damage. If the console is actually overheating and you bypass or ignore the fault, you risk permanent damage to the control board. If the sensor or wiring is simply faulty, the range may still restrict or prevent operation until the fault is cleared.

If the fix is a loose or corroded connector, there is no parts cost and only your time involved. A replacement console bimetal sensor typically costs between $15 and $50 for the part. If the control board itself has been damaged by overheating and needs replacement, that part can range from $150 to $350 or more depending on the model. Professional labor for a range repair generally runs $100 to $200 per hour, so diagnosing and resolving the issue yourself saves significant money if you are comfortable with basic electrical testing.