Wolf Hood Error Codes

4 error codes for Wolf hood models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

FCRecirculation filter alarm indicating the recirculation filter needs cleaning…FFFilter alarm reset confirmation displayed when the filter alarm has been…FGMesh filter alarm indicating the mesh grease filter needs cleaning.IRRemote Control activation or deactivation confirmation displayed on Black Hoods.

MyPros+ Max

Get the full diagnostic procedure for any Wolf hood error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Wolf Hood

FC on my Wolf Hood

M+

Recirculation filter alarm indicating the

From Service Manual 227981, p.33:

1.Hold Delay for 5 seconds (Black Hoods) or hold Filter for 5 seconds (Stainless/Glass Hoods) to reset Filter Alarm.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part WPW10804018

Electronic control board

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started