mypros+
Model reference

ADC AD120

Dryer

4 documents19 error codes1 service mode

Available documentation

Service Manual

  • Dimension Guide2 pg
    Covers this model
  • ADC AD-120 ServiceManual-AD-115,AD-120,AD-170,ML-120,AD-130,AD-145,AD-170 PH7 OPL70 pg
    Covers this model
  • ADC AD-120 PartsManual-AD-120ES-PH7 OPL60 pg
    Covers this model

Tech Sheet

  • 120-lb Dryer Spec-to-Spec Comparison1 pg
    Covers this model
MyPros+ Max

Diagnose your ADC AD120.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (19)

CodeMeaning
BAD EXHAUST TEMP PROBEIndicates the exhaust temperature probe is open or shorted.BURNER HIGH LIMIT FAULTIndicates the temperature disk in the burner has opened.BURNER IGNITION CONTROL FAULTNo signal to gas valve from Direct Spark Ignition (DSI) module during trial for…BURNER PURGE FAULTThe gas valve signal is present during the prepurge time.dSFLDisplayed when power is reestablished after temperature sensor probe…EE PROM FAULT ###Error in memory location; the ### indicates the location of the fault.EXHAUST HIGH LIMIT FAULTIndicates the temperature disk in the exhaust has opened.EXHAUST HIGH TEMP FAULTIndicates the temperature in the basket (tumbler) is above 220°F (104°C).FLAME FAULTFlame was detected during trial for ignition but failed sometime after…IGNITION FAULTGas valve did not remain open after trial for ignition; indicates no flame was…LINT ACCESS OPENIndicates the lint drawer is open and needs to be closed.LOW VOLTAGE FAULTIndicates power has dropped below operating values and will shutdown.MAIN DOOR OPENEDMain door is open when it should be closed.MODEL ERRORThe wrong model was selected for the dryer.OPEN S.A.F.E. SYSTEM PROBE FAULTIndicates the temperature probe for the S.A.F.EROTATION FAULTIndicates the basket (tumbler) is not rotating.S.A.F.E. SYSTEM ACTIVATEDThe S.A.F.ESAIL SWITCH CLOSED FAULTSail switch is closed when it should be open (prior to startup).SAIL SWITCH OPEN FAULTSail switch is open when it should be closed (opened during heating mode).

Service modes (1)

  • S.A.F.E. System Check Procedure["Ensure all water supply shutoff valves to the dryer are in the OPEN position.","Dryer must be in…

Full entry steps, exit procedures, and test sequences are available in Max.

Related ADC dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax