mypros+
Model reference

Amana 109W-3N

Air Conditioner

2 documents35 error codes5 service modes

Available documentation

Tech Tip

  • Instruction Sheet - 85312602 pg
    Covers this model
  • Instruction Sheet - 85244292 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 109W-3N.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
1-1Control detected K1 pilot relay stuck closed.1-2Control software issue10-1Dispenser electrical problem2-1Control detected stuck key(s) in keypad or keypad connection.3-1Open connector or component in Temperature Sensing circuit, open or faulty…3-2Shorted connection or component in Temperature Sensing circuit, shorted or…3-3OWI failed calibration, or drain hose check valve not sealing allowing dirty…4-3Wash motor not running5-1Door stuck open5-2Door stuck closed6-1Low or no water (mechanical problem)6-2Fill valve electrical problem6-3Suds or air in pump6-4Float switch open6-6Cool water7-1No heat7-2Heater stuck on8-1Slow drain8-2Drain motor electrical problem8-3Drain stuck on9-1Diverter problem (function 9, problem 1).9-2Diverter problem (function 9, problem 2).F0 E0No error(s) foundF1 E0EEPROM communications error.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F2 E0Shorted key / stuck key detected.F2 E1Keytail unplugged from control.F3 E0Oven temperature sensor opened (open circuit).F3 E1Oven temperature sensor shorted.
View all 35 error codes
F3 E2Bake/broil range over temperature condition.F3 E3Clean range over temperature condition.F5 E0Door latch and switches do not agree.F5 E1Door latch not operating (latch motor or switch failure).F5 E2Latch error during CLEAN cycle.

Service modes (5)

  • Cycle Advance (Cycle Operation Viewer)Press and hold Cycle Select for 5 seconds
  • Cycle Interval Advance (Cycle Operation Debug)Press and hold Cycle Select for 5 seconds
  • Service Diagnostics CycleWhile in standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds
  • Test/Diagnostic ModeWithin 60 seconds of power up, simultaneously hold down the BAKE and CLOCK keys for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass