Amana 113-3W

Error codes (23)

Service modes (25)

• Code Display Mode["PD Models
• Cycle Credit["Enter Washer Diagnostic Mode (entire display flashing).","Press the PERM
• Flashing Mode["PD Models
• Help Mode (dAS mode)["Enter set-up mode.","The message dAS will appear in the display.","Press the HOT button.","Press…
• Help Mode (Manual Communication)["Enter set-up mode.","Press the WARM button until set-up code 2.XX is on display.","Press the HOT…
• Help Mode (PD models)1
• Manual Overview Test["Enter Flashing Mode (entire display flashing).","Press the COTTON/WHITES button."]
• Manual Overview Test Cycle["Enter Washer Diagnostic Mode (entire display flashing).","Press the WHITES button to start the…
• Quick Overview Test["Enter Flashing Mode (entire display flashing).","Press the WARM button."]
• Quick Overview Test Cycle["Enter Washer Diagnostic Mode (entire display flashing).","Press the WOOLENS button to start the…
• Quick Spin Cycle["Enter Washer Diagnostic Mode (entire display flashing).","Press the COLORS button to start the…
• Service Access Code["If the washer is not in failure mode, the door must be opened to proceed.","Step 1
• Service Access Code (free-vend models only)1. Open the door. 2. Within 10 seconds, press in sequence
• Service Access Code (No Console Removal)["Only functions on washers set up for 0 vend price without any Special Pricing set-up, and…
• Service Diagnostic Test Modes1. Disconnect power and remove service door (PD models) or remove AA1 jumper from IU control board…
• Set-Up Mode (9150 Models)["Insert access door key, turn, and lift to remove access door."]
• Set-Up Mode (9160 Models via AA1 connector)["Unplug washer or disconnect power.","Open console, disconnect plug on AA1, close console.","Plug…
• Set-Up Mode (9160 Models)["Unplug washer or disconnect power.","Open console, disconnect plug on AA1, close console.","Plug…
• Set-Up Mode (PD Models)["Insert service access door key, turn, and lift to remove service access door."]
• Set-Up Mode (PR Models)["Install debit card reader per manufacturer's instructions.","Insert a set-up card (supplied by…
• Setup/Configuration Mode (PD models)Insert key into service access door, turn and lift to remove the service access door.
• Setup/Configuration Mode (PR models)Insert setup card (from card reader manufacturer) into card reader
• Washer Cleanout Cycle["Enter Washer Diagnostic Mode (entire display flashing).","Press the BRIGHTS button to start the…
• Washer Diagnostic Mode["First enter 'Start Operating Set-Up' (set-up mode).","Press and hold the DELICATES AND KNITS…
• Washer Diagnostic Mode (Flashing Mode)["First enter Set-Up Mode.","Press and hold the COLD button for 2 seconds while in set-up code 6…

Full entry steps, exit procedures, and test sequences are available in Max.