mypros+
Model reference

Amana 150A-3M

Air Conditioner

1 document28 error codes10 service modes

Available documentation

Tech Tip

  • Instruction Sheet - 39800578 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 150A-3M.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (28)

CodeMeaning
1Dryer thermistor short sensed10No wet clothes2Thermistor open sensed3Door circuit failure4Possible motor transistor error8Stuck keyAFRestricted air flow condition exists.dCDoor circuit failuredoDoor openE1Thermistor is open (open circuit detected in thermistor).E2Thermistor has shorted (short circuit detected in thermistor).E3User interface keyswitch or software mismatch between console panel/touchpad…F:01Primary control failure.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:24Inlet thermistor is open (only appears in diagnostic test mode).F:25Inlet thermistor is shorted (only appears in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted air flow condition exists (only appears in diagnostic test mode).F:50No voltage detected at the water valve relay (steam model only, only appears in…FEPower source frequency errorhEHeater errorL2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.tSDryer thermistor short sensed

Service modes (10)

  • Clear Diagnostic Codes1
  • Customer-Focused Drying Mode Adjustment["With the dryer in standby mode, press and hold the Dryness Level button for 5 seconds.","The…
  • Diagnostic Code DisplayWhile in Service Mode, press Wrinkle Prevent
  • Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
  • Display Diagnostic Codes1. Enter Service Mode. 2. Press Wrinkle Prevent key
  • Display Software Revision Number1
  • LED/Switch Check1
  • Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
  • Service Mode1
  • System Check Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass