mypros+
Model reference

Amana 210W-3J/P54655-26R

Air Conditioner

31 error codes5 service modes
MyPros+ Max

Diagnose your Amana 210W-3J/P54655-26R.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (31)

CodeMeaning
1-1Control detected K2 pilot relay stuck closed.1-2Control software issue; all LEDs are on due to software or hardware…10-1Dispenser electrical problem; loose connection in dispenser circuit and/or open…10-3Drying fan error; loose connection in fan circuit and/or open fan motor.2-1Control detected stuck key(s) in keypad or keypad connection.2-2User interface cannot communicate with main control; loose user interface…3-1Open connector or component in Temperature Sensing circuit (open or faulty…3-2Shorted connection or component in Temperature Sensing circuit, or incoming…3-3OWI (Optical Water Indicator) failed calibration.4-3Wash motor not running due to loose connection in motor circuit and/or faulty…5-1Door switch stuck open; loose connection in door switch circuit and/or door…5-2Door switch stuck closed; control detected door switch did not open between…6-1Low or no water reaching dishwasher (mechanical problem).6-2Fill valve electrical problem; loose connection in fill valve circuit and/or…6-3Suds or air detected in pump.6-4Overfill float switch stuck in overfill position and/or dishwasher not level.6-6Incoming water too cool (under 84°F / 29°C).6-7Flowmeter disconnected or damaged.6-8Water softener regeneration valve electrical problem (loose connection in regen…7-1No heat; control disabled heater due to detected water heating problem.7-2Heater stuck on; heater drive circuit on the control failed.8-1Slow drain due to obstructed drain hose or path.8-2Drain motor electrical problem; loose connection in drain motor circuit and/or…8-3Drain motor stuck on; drain motor drive circuit on the control failed.d1Dryer door sense error on control board or due to power line interference…d12Motor sense error on control board or due to power line interference; cycles…d13Blocked coin 2 or coin drop control circuit failure; coin recognition and…d16Control board not receiving communication from debit card reader in Enhanced…d4Dryer motor control circuit error; cycles and customer display disabled until…d5Blocked coin 1 or coin drop control circuit failure; coin recognition and…
View all 31 error codes
d9Low voltage detected; less than 90 volts for 8 seconds AC.

Service modes (5)

  • Customer Cycle Rapid Advance["Start a customer cycle.","Press HIGH TEMP
  • Diagnostic ModeDepress DELICATES for one second while in any of the set-up codes one through six (or while dAS…
  • Help ModePress the Whites & Colors keypad while in special pricing option step 2.XX (or while dAS displays…
  • Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
  • Service Diagnostics Cycle1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass