mypros+
Model reference

Amana 218D-3J-1

Air Conditioner

1 document21 error codes9 service modes

Available documentation

Other

  • W11082888 - Rev D64 pg
    Covers this model
MyPros+ Max

Diagnose your Amana 218D-3J-1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F0E2Oversuds condition detectedF0E4High water temperature detected during rinse cycle (105°F / 40°C or higher).F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Switch mismatchF3E1Pressure system faultF3E2Inlet water temperature fault; inlet thermistor detected to be open or shorted.F5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill / long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drain

Service modes (9)

  • Automatic Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Drain/Spin' LED is…
  • Calibration Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Rinse' LED is…
  • Fault Code Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until only the 'Done' LED is…
  • Manual Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Drain/Spin' and 'Done' LEDs…
  • Service Diagnostic Test Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 10 seconds after…
  • Service Diagnostic Test Modes (entry)["Ensure washer is in standby mode (plugged in with all indicators off). Wait 10 seconds after…
  • Software Version Display Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse,' 'Drain/Spin,' and…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Wash' and 'Done' LEDs are…
  • UI Test Mode["Enter Service Diagnostic Test Mode.","Turn cycle selector knob until 'Rinse' and 'Drain/Spin'…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass