mypros+
Model reference

Amana AXPK215-1A

Air Conditioner

53 error codes17 service modes
MyPros+ Max

Diagnose your Amana AXPK215-1A.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (53)

CodeMeaning
CLrNo fault detected; indicates normal operation with no error codes stored.E0-F1EEPROM communications failure, typically caused by power line noise or…E0-F2EEPROM checksum failure, typically caused by power line noise or lightning.E0-F3Key contact closed for more than 60 secondsE0-F5Clean temperature out of range (too high)E1-F1EEPROM communications failure, typically caused by power line noise or…E1-F2EEPROM checksum failure, typically caused by power line noise or lightning.E1-F3Break in oven sensor circuit (open sensor, loosened or disconnected sensor…E1-F5Door switch open during clean cycleE2-F3Short in oven sensor circuit (short in sensor, sensor shorted to casing…E3-F3BAKE/BROIL temperature out of range (too high)F0-0No error; initial factory setting.F1Internal circuit board failure / A/D error(s) (displayed as F1E0, F1E1, F1E2 on…F1-1Over temperature while cooking.F1-3Over temperature while cleaning.F1-5Cancel key input out of range.F1-7Keyboard disconnected.F1-8Shorted key.F1-9Slave micro not functioning.F1-AVCC/GND lift off.F1-CControl not calibrated.F1-EEEPROM data corruption.F1-E0EEPROM communications failure.F1-E1EEPROM checksum failure.F1-E2UL A/D error(s).F1E0Internal board failure / A/D error.F1E1Internal board failure / A/D error.F1E2Internal board failure / A/D error.F2Stuck/shorted key on the control panel (displayed as F2E0 on LCC 180/190…F2-E0Shorted key on the control panel.
View all 53 error codes
F2-E1Keytail unplugged from control board.F2E0Shorted key detected on the control keypad.F3Oven temperature sensor open circuit (displayed as F3E0 on LCC 180/190; also…F3-1Sensor or sensor circuit failure.F3-E0Oven temperature sensor circuit is open.F3-E1Oven temperature sensor is shorted.F3-E2Bake range over temperature condition.F3-E3Clean range over temperature condition.F3E0Oven temperature sensor opened (open circuit).F3E1Oven temperature sensor shorted.F3E2Bake/Broil range over temperature condition.F3E3Clean range over temperature condition.F5Door and latch switch mismatch during clean mode (displayed as F5E0, F5E2 on…F5-E0Door switch and latch switch do not agree (mismatch).F5-E1Door lock solenoid not operating or latch switch failure.F5-E2Latch during CLEAN error.F5E0Door and door position switches do not agree during Clean mode.F5E1Door latch not operating during Clean mode.F5E2Door and door position switches do not agree during Clean mode.F9Miswired house or miswired range.F9-1Auto latch will not lock.F9-2Auto latch will not unlock.F9E0Miswired house or miswired cooker power supply.

Service modes (17)

  • Child lock out["Press the 7 key and hold for 3 seconds."]
  • diagnosticPress CANCEL > CANCEL > START within 5 seconds.
  • Diagnostic Mode["Press CANCEL","Press CANCEL again","Press START","All three presses must occur within 5 seconds"]
  • diagnostic_test_modeAfter entering diagnostic mode (CANCEL>CANCEL>START), the initial display shows 'tSt' (LCC 90/95)…
  • Diagnostics ModePress CANCEL > CANCEL > START within a 5-second period.
  • Diagnostics Mode (3-digit LCC 90 and LCC 95 Control Display)Press CANCEL 2 times and then START within a 5-second period.
  • Diagnostics Test Mode (All LCC Controls)Press CANCEL 2 times and then START within a 5-second period. Then use individual key presses to…
  • Diagnostics Test Mode (Relay Checks)After entering Diagnostics Mode (CANCEL>CANCEL>START), press individual keys to test relays
  • Last Error Code RecallPress and hold the CANCEL/OFF key for 5 seconds until the last error code is displayed.
  • Manual Diagnostics Mode 1 (Full - within 120 seconds of power up)Within 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start
  • Manual Diagnostics Mode 2 (Limited - after 120 seconds of power up)After 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start
  • Sabbath mode (BAKE mode only)["Press BAKE, enter desired temperature and press START.","Press the 8 key and hold for 3…
  • Temperature Adjustment1
  • Temperature Adjustment (All LCC Controls)Step 1
  • Temperature adjustment (BAKE mode only)["Press BAKE pad.","Press in oven temperature of 500°F.","Immediately press and hold BAKE until…
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds
  • Temperature Calibration AdjustmentPress and hold the BAKE pad for 5 seconds. Current offset (if any) is shown in the 3-digit display…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax