Amana CRH5-3/P58372-30C

Error codes (37)

Service modes (26)

• Abbreviated White/Cottons Cycle TestWhile in Service Mode, press Delay Start (four times) followed by Start/Pause button.
• Board Output Test (EEPROM Test)Press and hold the Rinse, Prewash and Delay Start buttons, followed by the Power On/Off switch
• Board Output Test (EEPROM)Press and hold Rinse, Prewash and Delay Start, then press Power On/Off switch
• Component TestWhile in Service Mode, press the Start/Pause button to cycle through
• Diagnostic Mode (Washer Diagnostic Mode)["First access the Setup Mode (Start Operating Set-up).","Press and hold the QUICK CYCLE button for…
• Help Mode (Aide Mode)["PD models
• Help Mode (dAS Mode)["Open the service door or insert a manual diagnostic card.","The message dAS will appear in the…
• Help Mode (PD Models)["Open the service door.","Press the DELICATES AND KNITS button until the display reads…
• LED/Switch TestEnter the Board Output Test, then press the Temperature key (three times) followed by Start/Pause…
• Manual Overview Test["Enter Flashing Mode (diagnostic mode with entire display flashing).","Press the WHITES button."]
• Motor Output TestEnter the Board Output Test, then press the Temperature key (twice) followed by Start/Pause button
• Quick Overview Test["Enter Flashing Mode (diagnostic mode with entire display flashing).","Press the DELICATES AND…
• Quick Spin Program (Drain and Spin)["Enter Diagnostic Mode (display is flashing).","Press the COLORS button."]
• Rinse And Spin TestWhile in Service Mode, press Delay Start (seven times) followed by Start/Pause button
• Service Access Code (Code d'accès pour entretien)["Works only on washers configured for $0.00 sale price without Special Price, and Coin/Debit…
• Service Access Code (PN Models without key switch)["Only functions on washers set up for 0 vend price without any Special Pricing set-up, and…
• Service Mode1
• Setup Mode (Parameter Setting Mode)["PD models
• Setup Mode (PD Models)["Insert service access door key, turn, and lift to remove access door.","Use DELICATES AND KNITS…
• Setup Mode (PN Models)["Unplug washer or disconnect power.","Open console, disconnect plug on AA1, close console.","Plug…
• Spin TestWhile in Service Mode, press Delay Start (six times) followed by Start/Pause button
• Thermistor TestWhile in Service Mode, press Delay Start (two times) followed by Start/Pause button
• Unbalance TestWhile in Service Mode, press Delay Start (three times) followed by Start/Pause button
• Washer Cleaning Program["Enter Diagnostic Mode (display is flashing).","Press the BRIGHTS button."]
• Washer Diagnostic Mode["First enter 'Start Operating Set-Up' (setup mode).","Press and hold the QUICK CYCLE button for 1…
• White/Cottons Cycle TestWhile in Service Mode, press Delay Start (five times) followed by Start/Pause button.

Full entry steps, exit procedures, and test sequences are available in Max.