Model reference
Amana HRH5-1A
Air Conditioner
4 documents47 error codes19 service modes
Available documentation
Tech Sheet
- Tech Sheet - 9762991 - Rev A_97629916 pg
Installation Guide
- Installation Instructions24 pg
- Instrucciones de instalacion42 pg
- Installation Instructions17 pg
MyPros+ Max
Diagnose your Amana HRH5-1A.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (47)
CodeMeaning
1-1Control1-2Control10-1Other10-3Other2-1User Interface3-1Thermistor/OWI3-2Thermistor/OWI3-3Thermistor/OWI4-1Wash motor does not run4-2Wash motor5-1Door switch5-2Door switch6-1Water inlet6-2Water inlet6-3Water inlet6-4Water inlet6-6Water inlet6-7Water inlet6-8Water inlet7-1Heating7-2Heating8-1Drain8-2Drain8-3Drain9-1Diverter9-2Diverter9-3DiverterDrying (flashing) or Cool Down (flashing) or Finish Guard (flashing)The dryer door has been opened during a cycle (single STATUS LED flashing).Drying + Cool Down + Finish Guard (flashing)A power failure occurred during a dryer cycle.F0-E0No failureView all 47 error codes
F1EEPROM checksum failure or UL A/D error(s).F1-E0EEPROM communications failure.F1-E1EEPROM checksum failure.F1-E3Fuel type (gas/electric) select failure.F2EEPROM communications error or shorted key detected.F2-E0Key held down too long or shorted key.F2-E1Key tail unplugged or damaged.F2-E6Cancel key failure.F3Oven sensor opened, oven sensor shorted, BAKE/BROIL range over temperature, or…F3-E0Oven sensor opened.F3-E1Oven sensor shorted.F3-E2Bake range over temperature.F3-E3Clean range over temperature.F5Door and switches do not agree, door latch not operating, or latch error during…F5-E0Door and latch switches do not agreeF5-E1Door latch not operating.TIMED (flashing)The dryer thermistor or wiring to the thermistor is open or shorted.
Service modes (19)
- 12 Hour ShutoffPress and hold CLOCK pad for 5 seconds.
- Audible Signal Pitch ControlPress and hold DELAY START TIME pad for 5 seconds.
- Control LockPress and hold the Control Lock button for 5 seconds to toggle on/off.
- Diagnostics ModeWith oven not in cooking, broiling, or cleaning mode, press Cancel/OFF, Cancel/OFF, START. The…
- Disable/Enable All Tones (except end-of-timer and error tones)Press and hold COOK TIME pad for 5 seconds.
- Disable/Enable Cycle and Timer-End Repeating TonesPress and hold TIMER SET pad for 5 seconds.
- Dryer Diagnostic Mode["There is no formal test mode entry sequence for the dryer.","Diagnostics are performed by…
- Electronic Oven Control Test["1. Unplug the oven.","2. Remove the cabinet.","3. Discharge the HV capacitor with a 20,000 ohm…
- Error Code ReadingEnter Service Diagnostics mode (1-2-3-1-2-3-1-2-3)
- Fahrenheit to Celsius ConversionPress and hold BROIL pad for 5 seconds.
- Fahrenheit to Celsius TogglePress and hold BROIL key for 5 seconds.
- Rapid Advance Mode (Customer Cycles)Press HIGH TEMP
- Recall Last Failure CodePress and hold OFF/CANCEL pad for 5 seconds until last error code is displayed
- Sales Demonstration ModePress and hold TIMER OFF pad for 5 seconds.
- Service Diagnostics Cycle1
- Software Revision NumberPress and hold START/ENTER pad for 5 seconds.
- Temperature Adjustment ModePress and hold BAKE key for 5 seconds
- Temperature Calibration OffsetPress and hold BAKE pad for 5 seconds
- Washer Diagnostic Test Mode["Press the SELECT pad under TIME","Press the SELECT pad under TEMPERATURE","Press the SELECT pad…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana air conditioner models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass