Model reference

Amana VRCF30-U01A/P69210-4C

Name: Amana VRCF30-U01A/P69210-4C
Brand: Amana

Air Conditioner

1 document34 error codes6 service modes

Available documentation

Tech Sheet

Tech Sheet W1030148212 pg
Covers this model

MyPros+ Max

Diagnose your Amana VRCF30-U01A/P69210-4C.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Air Conditioner

AF on my Amana VRCF30-U01A/P69210-4C

M+

Restricted air flow condition exists.

From Tech Sheet W15067117, p.49:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (34)

CodeMeaning

AFRestricted air flow condition exists.CALL SErvAmperage monitoring system on H.V DoorDoor Interlock Primary Switch fault.Err1Failed H.V Err2Failed H.V Err3Failed H.V Err4Failed H.V Err5Shorted Touch Panel.Err6Failed H.V F:01Primary control failure.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:24Inlet thermistor is open (only appears in diagnostic test mode).F:25Inlet thermistor is shorted (only appears in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted air flow condition exists (only appears in diagnostic test mode).F:31Low voltage condition (less than 30 V) has been detected (appears ONLY in…F:50No voltage detected at the water valve relay (steam model only, only appears in…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).

View all 34 error codes

F:78Console electronics failure (F:72 through F:78).HOTThermal protection activated due to open TCO, inoperative blower motor…L2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.

Service modes (6)

CALL SErv Reset["Unit must be in OFF condition or INITIAL power up mode.","Oven door must be closed.","Press…
Customer-Focused Drying Mode Adjustment["With the dryer in standby mode, press and hold the Dryness Level button for 5 seconds.","The…
Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)["In Standby mode (dryer plugged in but not powered up), press and hold the Dryness Level button…
Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Done…
Service Test Mode["Unit must be in OFF condition or INITIAL power up mode.","Oven door must be closed.","Press…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana air conditioner models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass