mypros+
Model reference

Amana AKD-1B

Cooktop

8 documents44 error codes21 service modes

Available documentation

Tech Sheet

  • TECH SHEET - Instruction Sheet 85242644 pg
    Covers this model
  • Tech Sheet - 36-32090801-08 pg
    Covers this model
  • Tech Sheet - 160216234 pg
    Covers this model
  • Electric Freestanding Range—Technical Information11 pg
    Covers this model

Service Manual

  • Service Manual - RX242001.pdf25 pg
    Covers this model
  • 30″ Freestanding Self-Cleaning Electric Range72 pg
    Covers this model
  • Job Aid - 8178042 (KR-31)72 pg
    Covers this model
  • Troubleshooting Gas and Electric Freestanding Range Electronic Controls70 pg
    Covers this model
MyPros+ Max

Diagnose your Amana AKD-1B.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (44)

CodeMeaning
:Power failure indication1c1cShorted key detected on the control circuit board.1c2cKeyboard tail disconnected from the control circuit board.1c31Cancel key circuit problem.1c6cEEPROM error1c7cControl not calibrated1c8cCooking program error1d11Runaway oven temperature (650°F) detected while door is unlocked; sensor…1d21Runaway oven temperature (950°F) detected while door is locked; sensor…3d11Oven temperature sensor open3d21Oven temperature sensor shorted4d11Door switch position failure4d51Door switch circuit failure9d11Door latch will not lock9d21Door latch will not unlock9d31Latch state unknownF0 E0Factory defaultF1Control malfunction.F1 E*Control board failure (all F1 sub-codes indicate control fault).F1 E0EEPROM communications error.F1 E1EEPROM checksum error.F1 E2UL A/D error(s).F1 E4Model ID error.F1 E6Latch signal mismatch error.F2Over temperature while cleaning.F2 E0Shorted key.F2 E1Key tail unplugged.F3Sensor probe open or shorted.F3 E0Oven sensor openedF3 E1Oven sensor shorted
View all 44 error codes
F3 E2Bake/broil range over temperature.F3 E3Clean range over temperature.F3 E4Oven sensor openedF3 E5Oven sensor shortedF3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F5Keyboard disconnected.F5 E0Door switches do not agree.F5 E1Door latch not operating.F5 E2Door switch fault.F6MW relay (Relay 4903) failure.F6 E*Control communication failure.F8 E0N/A.F9Slave micro not functioning.

Service modes (21)

  • 24-Hour Clock Toggle["Press and hold CANCEL and DELAY pads for 3 to 5 seconds."]
  • Child lock outPress Function 1 pad.
  • Clock Display Toggle["Press and hold CANCEL and CLOCK pads for 3 to 5 seconds."]
  • Diagnostic Code Display["Press and hold UP ARROW pad and apply power to the unit.","Cycle through the codes using the…
  • Diagnostic Code Display Mode["Press and hold UP ARROW pad and apply power to the unit.","Cycle through the codes using the…
  • Factory Default Reset["Press and hold CANCEL and KEEP WARM pads for 3 to 5 seconds."]
  • Last Error Code RecallPress and hold CANCEL/OFF key for 5 seconds until last error code is displayed.
  • LCC Diagnostic Mode (LCC90/LCC95/LCC180)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • LCC190 Diagnostic Mode (Self Clean, Convection models)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME or TEMP/HOUR '+' key to cycle through…
  • MRC Diagnostic Mode["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • MRC Diagnostic Mode (Fan/True Convection Electric - Oven Light entry)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' key to cycle through diagnostic…
  • MRC II Diagnostic Mode (Number 3 key entry - KitchenAid models)["Press OFF/OFF/START or CANCEL/CANCEL/START in sequence.","Press the number '3' key to cycle…
  • MRC II Diagnostic Mode (TEMP/TIME entry)["Press CANCEL, CANCEL, START in sequence.","Press TEMP/TIME '+' keypad to cycle through diagnostic…
  • Oven Temperature Adjustment["Press BAKE pad.","Enter 550 on the digit-pad.","Immediately press and hold BAKE pad for 3 to 5…
  • Quick Test Mode["Must be entered within the first 5 minutes of applying power.","Press and hold CANCEL and BROIL…
  • Sabbath Mode["Hold CLOCK button for 3 to 5 seconds to activate Sabbath mode."]
  • Sabbath mode (BAKE mode only)Press Function 2 pad while in BAKE mode. After pressing 2 pad the SABBATH icon will illuminate…
  • Self-Diagnostic / Touch Panel and PCBA Test["Press and hold the STOP/CLEAR button while opening the door.","While still holding the STOP/CLEAR…
  • Temperature adjustment (BAKE mode only)Press Function 6 pad. Then press slew up or down pads to adjust. The + or
  • Temperature Calibration AdjustmentPress and hold BAKE pad for 5 seconds
  • Temperature Display Toggle (°F/°C)["Press and hold CANCEL and BAKE pads for 3 to 5 seconds."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana cooktop models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass