mypros+
Model reference

Amana U23K/P60250-4W

Freezer

4 documents68 error codes10 service modes

Available documentation

Tech Sheet

  • Wiring Diagram - W10694076 - Rev A2 pg
    Covers this model
  • Wiring Diagram3 pg
    Covers this model
  • Wiring Diagram2 pg
    Covers this model

Service Manual

  • service manual W1133862052 pg
    Covers this model
MyPros+ Max

Diagnose your Amana U23K/P60250-4W.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (68)

CodeMeaning
E0Manufacturing codeE0-F1EEPROM communications failure, possibly caused by power line noise or lightning.E0-F2Key contact closed for more than 60 secondsE0-F3Break in oven sensor circuitE0-F5Door switch open during CLEANE1Manufacturing codeE1-F1EEPROM CHECKSUM failure, possibly caused by power line noise or lightning.E1-F2No communication between keyboard and controlE1-F3Short in oven sensor circuitE1-F5Latch switch not operatingE2Manufacturing codeE2-F3BAKE/BROIL temperature out of range (too high)E3Manufacturing codeE3-F1Fuel type (gas/electric) select failureE3-F3Clean temperature out of range (too high)E4Ice maker errorE5Ice maker errorE6Manufacturing codeE6-F2STOP/CLEAR key contact closed for more than 60 secondsErManufacturing codeF0E0No failureF1Internal control board failure (A/D errors).F1-E0EEPROM checksum failure.F1-E1UL A/D error(s).F1E0Internal error (display board related).F1E1Internal error (display board related).F1E2Internal error (display board related).F1E3Internal error (display board related).F1E4Internal error (display board related).F1E5Internal error (power board related).
View all 68 error codes
F1E6Internal error (power board related).F1E7Internal error (power board related).F1E8Internal error (power board related).F1E9Internal error (display board related).F2Oven sensor opened, oven sensor shorted, bake/broil range over temperature, or…F2-E0Shorted key detected.F2-E1EEPROM communications error.F2E0Stuck key (shorted key) on keypad.F2E1Keypad disconnected.F3Shorted key on the control board.F3-E0Oven sensor opened.F3-E1Oven sensor shorted.F3-E2BAKE/BROIL range over temperature.F3-E3CLEAN range over temperature.F3E0Main oven temperature sensor open (top oven sensor opened).F3E1Main oven temperature sensor shorted (top oven sensor shorted).F3E2Meat probe sensor shorted.F3E3CLEAN range over temperature condition.F3E4Bottom oven temperature sensor open (bottom oven sensor open).F3E5Bottom oven temperature sensor shorted (lower oven sensor shorted).F3E6Warming drawer temperature sensor open.F3E7Warming drawer temperature sensor shorted.F4E2Over temperature during cook mode.F4E3Over temperature during clean mode.F4E7Over temperature cavity 2 (temperature runaway error).F5Door and switches do not agree (Clean mode) or door latch not operating (Clean…F5-E0Door and switches do not agree.F5-E1Door latch not operating.F5-E2Latch error during CLEAN.F5E0Door latch mismatchF5E1Latch not operating (no operating latch).F5E2Door switch fault.F5E4Latch switch fault.F5E7Unlock door errorF6E4Lost communication between power board and display board.F6E5Cancel key error.F9Miswired house or miswired range (LCC 90/95).F9E0Miswired house or miswired range.

Service modes (10)

  • Diagnostic mode["Press the Cancel key to place the range in an idle state.","Press the Cancel and Start keys in…
  • Diagnostics ModeWith the oven not in cooking, broiling, or cleaning mode, press Cancel/OFF, Cancel/OFF, START. The…
  • Diagnostics Test Mode (Relay Checks)After entering Diagnostics Mode (CANCEL>CANCEL>START), press individual keypads to test relays
  • Forced Defrost Mode (Service Test 38)1. Enter Service Diagnostics Mode. 2. Navigate to Step 38. 3. Select SW3 to toggle
  • Manual Diagnostics Mode 1Within 120 seconds of power up, press STOP/CLEAR, STOP/CLEAR, then START.
  • Manual Diagnostics Mode 2After 120 seconds of power up, press STOP/CLEAR, STOP/CLEAR, then START.
  • Oven Temperature Adjustment (Calibration)Press and hold BAKE pad for 3 seconds. Current offset shown in 3-digit display, CAL shown in…
  • Service Diagnostics Mode1
  • Temperature AdjustmentStep 1
  • Temperature Adjustment ModePress and hold BAKE key for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana freezer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass