mypros+
Model reference

Amana YY-80-PA

Furnace

5 documents34 error codes13 service modes

Available documentation

Tech Sheet

  • tech sheet w11359197 reva2 pg
    Covers this model

Tech Tip

  • Instruction Sheet - 397920812 pg
    Covers this model
  • Instruction Sheet - 854179812 pg
    Covers this model
  • Instruction Sheet - 397921012 pg
    Covers this model

Installation Guide

  • Installation Instructions24 pg
    Covers this model
MyPros+ Max

Diagnose your Amana YY-80-PA.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (34)

CodeMeaning
F0E1Load detected during the washer cleaning cycleF1E0EEPROM communications error.F1E1EEPROM checksum failure.F1E2UL A/D error(s).F1E4Microwave ACU PCBA failure.F2E0Shorted keypad.F2E1Stuck key failure on the touch panel.F2E3Unsupported CycleF3E0Oven sensor opened.F3E1Oven sensor shorted.F3E2Bake range over-temperature.F3E3Clean range over-temperature.F4E1Cavity temperature sensor failure.F4E4Humidity sensor error.F4E9AccuPop error.F5E0Door and latch switches do not agree.F5E1Solenoid not operating or latch switch failure.F5E2Door Lock ErrorF5E3Door Unlock ErrorF6E1Communication Error between CCU and MCUF6E2Communication Error UI to CCUF6E3Communication Error CCU to UIF7E1Drive Motor Tachometer Error / Washer OverloadF7E2MCU Fault or Motor OverheatF8E0Steam Inlet Valve ErrorF8E1No water detected entering washer or pressure switch trip not detectedF8E2Dispenser System ErrorF8E3Overflow ConditionF8E4Flow Meter FaultF8E5Exhaust air template detector (HF NTC thermistor) failure.
View all 34 error codes
F9E1Long DrainIntInterruptedrLRemove LoadSudSuds detected

Service modes (13)

  • Advancing Through Saved Fault/Error Codes1
  • Clear Fault Codes1
  • Damp Dry Test["Begin with an empty dryer and clean lint screen","Set Timer to DAMP DRY","Set Fabric…
  • Diagnostic/Test Mode["Plug in microwave oven or reconnect power.","Press CANCEL keypad to Standby mode (displays…
  • Diagnostics mode (Failure code verification)["Press CANCEL","Press CANCEL","Press START"]
  • Factory Test["Open the door","Set Signal switch to HIGH","Set Timer to TIMED DRY or AUTO MOISTURE SENSING PLUS…
  • Fault Code Display / Advance1
  • Oven temperature calibrationPress and hold the BAKE keypad for 5 seconds. 'CAL' is shown in the display. Press the TEMP/TIME Up…
  • Quick Diagnostics1
  • Service Diagnostic Mode1. Ensure washer is in standby mode (plugged in with all indicators off). 2. Select any three…
  • Software Version Display1
  • Touch Panel and ACU PCBA Test (Test Mode)["Plug in microwave oven or reconnect power and press the Cancel keypad to standby (':')","Close…
  • User Interface Test1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana furnace models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass