Model reference

Amana IC-2

Ice Maker

9 documents39 error codes6 service modes

Available documentation

Tech Sheet

Tech Sheet - RT32200028 pg
Covers this model
Tech Sheet - RT32200049 pg
Covers this model
Tech Sheet - RT32200038 pg
Covers this model
Tech Sheet - RT32200069 pg
Covers this model
Tech Sheet - W116452482 pg
Covers this model
Tech Sheet2 pg
Covers this model
Tech Sheet - W10814253 - Rev A2 pg
Covers this model

Installation Guide

Installation Instructions8 pg
Covers this model
Installation Instructions4 pg
Covers this model

MyPros+ Max

Diagnose your Amana IC-2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (39)

CodeMeaning

E0No errors, functioning ice maker.E1No cooling E2Motor lost position E3Heater time-out E4Dry cycle E5Ice maker thermistor is bad F0E2Oversuds condition detected during wash cycle.F0E3Overload condition detected.F0E5Off balance load detected.F0E6Machine orientation error F0E7Load detected when running Clean Washer cycle.F0E8Water ring condition detected.F0E9Off balance pause condition.F1E2Motor drive module over or under voltage condition.F1E3Accelerometer not responding.F2E1User interface (UI) stuck button detected.F2E2User interface (UI) disconnected from control.F3E2Pressure system fault detected.F3E5Mini Bulk (auto-dispenser) system error.F5E1Lid switch fault F5E3Lid will not lock or unlock.F5E4Lid not opened between cycles.F6E1Communication error F6E2Communication error F6E3Communication error F7E2MCI drive failure.F7E3Basket engaged during wash.F7E4Basket re-engagement failure.F7E7Motor unable to reach target RPM.F7E8Motor drive module over temperature.

View all 39 error codes

F7E9Locked rotor condition detected.F7EAMotor phase lost.F8E1Long fill F8E2Pressure system fault.F8E3Overflow or flood condition detected.F8E6Water hazard condition detected.F9E1Long drain fault FCE1Model and serial numbers not programmed.FCE2Model and serial numbers do not match.

Service modes (6)

Moisture Sensor Board Self-Test["Tape a small piece of metal joining the two moisture sensor bars together.","Close loading door…
Moisture Sensor Signal Test["Connect jumper wire between H1-2 and H1-12
Service Diagnostic Mode["Ensure the washer is in standby mode (plugged in with all indicators off).","Select any three (3)…
Service Diagnostics Mode["Ensure refrigerator is not in lockout mode.","Press SW1 and SW2 simultaneously for 3…
Signal Test["Connect jumper wire between H1-2 and H1-12
Timer Motor Triac Output Circuit Test["Connect a 120 VAC / 60 Hz (10 W max.) light between Pins H1-6 and H1-11 to monitor…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana ice maker models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass