Model reference
Amana MVH-1020
Microwave
2 documents39 error codes13 service modes
Available documentation
Tech Sheet
- TECH SHEET - 8304554 - Rev C16 pg
Installation Guide
- Installation Instructions7 pg
MyPros+ Max
Diagnose your Amana MVH-1020.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (39)
CodeMeaning
AFRestricted airflow condition detected during operation.F-01Primary control failure.F-02Stuck button or user interface mismatch (only appears in diagnostic test mode).F-22Exhaust thermistor is open.F-23Exhaust thermistor has shorted.F-24Inlet thermistor is open (only appears in diagnostic test mode, electric models…F-25Inlet thermistor has shorted (only appears in diagnostic test mode, electric…F-26Motor drive system failure.F-28Moisture sensor strip is open (only appears in diagnostic test mode).F-29Moisture sensor strip has shorted (only appears in diagnostic test mode).F-30Restricted airflow condition (only appears in diagnostic test mode, electric…F0E0Default errorF1E0Internal errorF1E1Internal errorF1E3Internal errorF1E4Internal errorF1E5Internal errorF2E0Keypad disconnected.F2E1Stuck or shorted key.F3E1Lower oven sensor shorted or open.F3E2Warming drawer sensor shortedF3E3Meat probe sensor shorted.F4E1Convection thermistor error (microwave sensors).F4E2Internal temperature sensor error (microwave sensors).F4E4Humidity sensor error (microwave sensors).F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6E0Lost communications between user interface and appliance manager.F6E1Cook oven over temperature.F6E2Clean oven over temperature.View all 39 error codes
F6E3Mini oven/warm drawer over temperatureF6E4User interface / appliance manager mismatch.F6E5No cavity size command.F7E0Water is not high enough or water did not boil fast enough.F7E1Boiler over temperature.F7E2Boiler NTC out of range.F7E3Improper filter reset.F7E4Conductivity sensor not connected.PFPower failure occurred while the dryer was running.
Service modes (13)
- customer_focused_drying_mode_adjustment1
- Customer-Focused Drying Mode Adjustment1. Dryer must not be running. 2. Press and hold the DRYNESS button for 5 seconds. 3. Dryer will…
- diagnostic1
- Diagnostic - Displaying Inlet AirflowAfter entering diagnostic test mode and advancing past all saved fault codes, press the Wrinkle…
- Diagnostic - Displaying Line VoltageAfter entering diagnostic test mode and advancing past all saved fault codes, press the End of…
- Diagnostic Menu - Extended Mode1. Enter Diagnostic Mode (OFF, OFF, START). 2. Configure cavity size to 30 inches by pressing 30…
- Diagnostic ModePress OFF, OFF, START.
- Diagnostic Test Mode1
- diagnostic_airflow_display1
- diagnostic_line_voltage_display1
- Manual Load Test1. Ensure dryer is in standby mode. 2. Select any one button (except Pause/Cancel). 3. Press and…
- manual_load_test1
- Model ID and Cavity Size Programming (after UI replacement)1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana microwave models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass