Model reference

Amana RS40/P76695-19M

Microwave

8 documents19 error codes10 service modes

Available documentation

Tech Tip

certificateofconformity-w10359171-reva.pdf1 pg
Covers this model

Installation Guide

Installation Instructions32 pg
Covers this model
Installation Instructions32 pg
Covers this model
Installation Instructions27 pg
Covers this model
Installation Instructions30 pg
Covers this model
Installation Instructions22 pg
Covers this model
Instrucciones de instalacion56 pg
Covers this model
Installation Instructions30 pg
Covers this model

MyPros+ Max

Diagnose your Amana RS40/P76695-19M.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (19)

CodeMeaning

2EVoltage for motor control bus is over or under specified limit (diagnostic code…3EMotor failure bEMotor tach signal exists without motor running or when not expected (abnormal…dcUnbalanced load detected during final spin prevented the spinner from exceeding…dLOpen door lock switch detected with motor running.dSDoor switch is read as open and the door locked switch is read as locked during…E2Stuck key detected E3Machine control is attempting to drive the motor but is not seeing any tach…FLDoor failed to lock after 3 attempts.HrHeater Relay failure LEWater level sensor fault LODoor failed to unlock after 3 attempts.ndThe water level fails to drop below the Low Water level reset within 15 minutes…nFContinuous fill of 12 minutes or total fill of 14 minutes without reaching…odThe door has not been opened after two complete wash cycles; door switch was…OEWater level sensor fault SrSystem Relay failure SUDsWasher is in a suds period; displayed instead of remaining time.tESump thermistor failure

Service modes (10)

Board Input TestWhile in Service Mode, press the Spin Only key.
Board Output Test / System CheckWhile in Service Mode, press the Spin Speed key.
Cycle CountWhile in Service Mode, press Chime.
Diagnostic Code DisplayWhile in Service Mode, press Rinse&Spin key (displays 'd'), then rotate Cycle Selector knob in…
Display Software VersionWhile in Service Mode, press Soil Level
Fast Time-Down / Advance to Next StepWhile any test or cycle is running in Service Mode, press the Temperature key to advance the…
LED/Switch TestWhile in Service Mode, press the Delay key for 3 seconds, then press individual buttons to test.
Quick Service CycleWhile in Service Mode, press Temperature and Soil Level keys for 3 seconds.
Quick Spin TestWhile in Service Mode, press Delay Start and Rinse&Spin keys.
Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana microwave models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass