mypros+
Model reference

Amana ASC-1B/P85122-4S

Range

33 error codes5 service modes
MyPros+ Max

Diagnose your Amana ASC-1B/P85122-4S.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (33)

CodeMeaning
C1Blocked coin 1 or coin drop control circuit failure (coin recognition and price…C2Blocked coin 2 or coin drop control circuit failure (coin recognition and price…EdNot receiving communications from installed debit card reader in Enhanced…F0E0No failure (GOOD)F1E0Oven user interface component failure.F1E1Oven appliance manager component failure.F1E2Microwave user interface component failure.F1E3Microwave appliance manager component failure.F1E4Microwave power relay component failure.F1E5Microwave inverter component failure.F2E0Keypad disconnected.F2E1Stuck or shorted key on keypad.F3E1Lower main oven temperature sensor shorted or open.F3E2Warming drawer sensor shorted or open (oven not equipped with this feature).F3E3Meat probe sensor shorted.F4E1Microwave convection thermistor sensor failure.F4E2Microwave internal (ambient) temperature sensor failure (integrated on MW…F4E4Microwave humidity sensor failure.F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6E0Lost communications between user interface and appliance manager.F6E1Cook oven over temperature.F6E2Clean oven over temperature.F6E3Mini oven/warm drawer over temperature (oven not equipped with this feature).F6E4User interface and appliance manager mismatch.F6E5No cavity size command programmed in control.LdWasher lid sense error on control board or due to power line interference…LFWater level detection error on control board or due to power line interference…LSMotor sense error detected on control board or due to power line interference.LVVoltage detected below 90 VAC for 8 seconds.
View all 33 error codes
SdLast drain occurring during final spin was slow.SFLast fill was slow.tFWater temperature sense error when equipped with temperature sensing water…

Service modes (5)

  • diagnostic["Press the OFF key.","Press the OFF key.","Press the START key.","If control does not enter…
  • diagnostic mode["Enter set-up mode first.","While in any of the set-up codes 1 through 6, anytime a diagnostic…
  • field diagnostic cycle["Enter diagnostic mode (entire display flashing).","Press the LOWER MIDDLE key pad to start the…
  • help mode["Enter set-up mode first.","Navigate to special pricing option mode (code 2.XX).","Press the LOWER…
  • set-up mode["PD Models

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass