Model reference

Amana KENMORE/ELITE

Refrigerator

4 documents25 error codes5 service modes

Available documentation

Tech Sheet

Kenmore Whirlpool Dryer 110 86742700 Tech Sheet W10143266A12 pg
Covers this model

Wiring Diagram

Kenmore Whirlpool Refrigerator 110 60852990 Service Wiring Sheet2 pg
Covers this model

Service Flash

Special Door Reversal Instructions - Bottom Mount and Top Mount3 pg
Covers this model

Other

Whirlpool Kenmore Front Load Washer Clean Out Procedure2 pg
Covers this model

MyPros+ Max

Diagnose your Amana KENMORE/ELITE.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Refrigerator

AF on my Amana KENMORE/ELITE

M+

Low inlet air flow detected at install.

From Tech Sheet W13714875, p.47:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFLow inlet air flow detected at install.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in Diagnostic Test Mode).F:25Inlet thermistor is shorted (appears ONLY in Diagnostic Test Mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:30Restricted air flow condition exists (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30 V) detected (appears ONLY in Diagnostic…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure.F:73Console electronics failure.F:74Console electronics failure.F:75Console electronics failure.F:76Console electronics failure.F:77Console electronics failure.F:78Console electronics failure.L2Low line voltage (less than 30 V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (5)

Customer-Focused Drying Mode Adjustment1
Inlet Air Flow Diagnostic1
Line Voltage Diagnostic1
Manual Load Test1. Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Clothes…
Service Diagnostic Test Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass